If you have a dead battery in your motorcycle, you may need to learn how to bump start your motorcycle. Luckily, this process is fairly simple and will fix many problems. To start, you can use a black cable to push the tires together to generate traction. Before you attempt this process, check the fuel level of your bike.
Push-starting a motorcycle with a dead battery
There are several steps to push-start a motorcycle with a dead battery. One way is to connect a 12 V battery to a motorcycle in reverse gear. You do not need the engine running to push the bike into gear, but it is best to keep the engine running to ensure the battery gets the charge it needs.
After you push-start the motorcycle, try to rev the engine several times. This will help the battery regain its charge and prevent future push-starts.
Using a black cable
If you’re out on the road and your battery doesn’t seem to be charging properly, you can try using a black cable to jump-start your motorcycle. You’ll need two cables: one red for the positive terminal of the dead bike and one black for the negative terminal. You can connect the black cable to the negative terminal of the dead motorcycle by touching it on the metal surface of the bike. You should crank the motorcycle for a few seconds, but do not push too hard. Be aware that you could spark the dead battery and ignite the gasses, so be careful.
The first thing you should do is check the battery. A bike battery can run out of life very easily, so check the warning lights before starting a bump. Also, make sure your battery connection is solid. Even if your bike started perfectly yesterday, it might not work well today. A black cable is a quick and easy way to fix this problem.
Pressing the tires together to create traction
Pressing the tires together to create traction is an important process. Maintaining traction when rolling on and off the throttle is a good idea. To do this, roll on the throttle slowly and smoothly. When braking, apply the brakes progressively over two seconds.
If you squeeze the tires together, you will lose traction and ride too rough. It can also lead to overheating of the tires. It may also cause the rear end to “kick” when you go over a bump.
Checking the fuel level
Checking the fuel level before bump starting your motorcycle is essential to ensure it will start without any problems. If you don’t have a fuel gauge, fill it up before a trip of about 200-250 kilometers. Generally, three liters of fuel should be enough to run for 60 km.
Before bump starting your motorcycle, check its fuel level and battery. If the motorcycle is stalled or has a low battery, you can use the battery to recharge it. Also, you can rev the engine. You should always crank the motorcycle slowly and gently – no more than two seconds at a time.
Using a jumper cable
Using a jumper cable may be the best option if your motorcycle won’t start. While jumper cables for cars are large and bulky, they are much easier to carry on your motorcycle. They are also much lighter and can fit inside your saddlebag. Just be sure to make sure that the connectors are tight.
Start by connecting the two cables. The positive terminal of the jumper should connect to the dead battery’s positive terminal. In contrast, the negative terminal should connect to a grounded metal surface like the chassis. Once connected, turn the motorcycle on and run it for a few minutes.